maintenance
Adjusting the Mower Deck
Leveling Deck
Adjust the deck while the mower is on a level surface. Make sure the tires are inflated to the correct pressure. See Tire Pressures in Maintenance section. If tires are under or over inflated, the deck cannot be properly adjusted. Faulty mower deck adjustments will cause an uneven mowing result.
Four bolts control the height and pitch of the mower deck. The deck should be adjusted slightly higher in the rear.
NOTE: To insure accuracy of leveling procedure, mower deck drive belt must be installed prior to leveling the deck.
1.Wear heavy gloves. Turn each outer blade tip to align the deck in a
2.Measure from the floor surface up to the bottom of the blade tip on the discharge side of the mower deck. Retain this measurement. Move to the opposite side; check that measurement is the same. If adjustment is required, loosen the locknut and adjust bolt up until both
3.Turn both outer blades to align with the deck in
4.Confirm measurements once again. Blade tip height should be equal in a
NOTE: This will place the mower deck in a base measurement position. Additional adjustment may be required to achieve desired cut for the type of grass or conditions being mowed.
WARNING!
Blades are sharp. Protect your hands with gloves and/or wrap blades with a heavy cloth when handling.
1 |
2 |
1.Adjustment bolt
2.Locknut
Leveling the mower deck
49
