Husqvarna B1100028 manual Sub System Software, Test Out and Test, Demo mode

SERVICE

5

B1100028

English 2 (5)

Calibration of guide is done automatically first time the mower leaves the charging station in the following situations:

•New mower first start up

•Always at Test Out

•After changing guide width to Medium or Wide

•After performing Factory reset

•After changing main circuit board

•After main software update

Sub System Software

In mower menu Tools -> Info -> General, the line “Sub-ver” has been added. That software con- trols the cutting motor. The Sub system software is updated together with the Main and MMI soft- wares when Automatic programming is done in Autocheck EXP.

Test Out and Test In

As a result of improved Calibration of Guide some changes have been done in the Test Out and Test In procedure.

•Test Out must be done before Test In.

•If Test In is done before Test Out the mower will run on top of wire to the charging station, irrespective of guide width setting. This should not be considered as a valid test.

Demo mode

Demo mode is available in menu Tools -> Special Settings -> Demo Mode. In demo mode Automower® 305 works without starting the blade disc. The mower varies running with charging at four minute intervals.

Note!

-It is strongly recommended to use demo mode whenever running Automower® in public demo areas, for example inside a dealer’s shop. Blade disc is switched off in demo mode for increased safety.

-Always remove the blades from the blade disc whenever Automower® is demonstrated in public areas for increased safety.

-Demonstration of Automower® without using demo mode may only be done if the mower is constantly under observation.