Husqvarna BP5 manual Maintenance, Storage, Disposal

BP5
8. Maintenance	9. Storage

Before you remove cap, be sure there is no pressure in the tank. in order to release pressure, invert unit upside down and squeeze spray pistol (aim away from you). Pressure will escape; when hissing stops, all pressure has been released. Remove pump assembly by turning counter-clockwise. The pump handle has two locking positions, one turning clockwise and one counter-clockwise.

1.Remove cap and pour out remaining solution, then rinse all parts thoroughly with clean water.

2.Add 1/2 gallon of fresh water in tank. Pressurize, and flush pumping system by depressing trigger for at least two minutes; then drain all remaining water.

•Periodically re-grease lid gasket as well as lid vent and pump cylinder, where applicable.

•To ensure good performance, keep lid vent free of obstruction.

•Before and after each use, make sure all connections are well tightened. Service and replace worn parts as required.

Failure to follow manufacturer’s recommendation of use and care of unit will void any expressed or implied warranty. Do not use chlorine or clorox. It will permanently damage pump system.

In the event that any part must be replaced or any maintenance or repair work not described in this manual must be performed, please contact a Husqvarna authorized servicing dealer for assistance.

SPRAYER MAINTENANCE TABLE

		Daily
		or
System/Component	Procedure	Before Use	After Use
Lid Gasket	Grease	3
Lid Vent	Inspect/Clean	3
Pump	Grease	3
Connection	Inspect/Tight	3
Whole unit	Wash/inspect		3

Never store chemicals in your sprayer for any length of time

1.Before you remove cap, be sure there is no pressure in the tank. in order to release pressure, invert unit upside down and squeeze spray pistol (aim away from you). Pressure will escape; when hissing stops, all pressure has been released. Remove pump assembly by turning counter-clockwise. The pump handle has two locking positions, one turning cloc kwise and one counter-clockwise.

2.Remove cap and pour out remaining solution, then rinse all parts thoroughly with clean water.

3.Add 1/2 gallon of fresh water in tank. Pressurize, and flush pumping system by depressing trigger for at least two minu tes; then drain all remaining water.

4.Always store tank clean and empty in a dry, shaded location.

10. Disposal

When disposing of your machine, or chemical, be sure to follow your local regulations.

US-8