Husqvarna C42C owner manual Tips For Improved Bagging Operation

Models: C42C

1 15
Download 15 pages 8.63 Kb
Page 11
Image 11
OPERATION

OPERATION

TIPS FOR IMPROVED BAGGING OPERATION:

Follow the mower operation instructions in your tractor owner's manual.

When operating your grass catcher on a lawn where grass and leaf bagging equipment has not been used, you are picking up thatch and debris that has accumulated for long periods of time. The amount collected and the total time of operation may be greater than you will experience with regular use of your grass catcher.

Always run throttle at full speed when bagging.

Select a gear low enough to give good mower cutting performance, good quality cut and good bagging perfor- mance.

NOTE: It may be necessary to overlap width of cut to suit your conditions.

If grass is extremely tall, it should be mowed twice. The first time relatively high, the second time to desired height.

Use left hand side of mower for trimming.

Plastic trash bags can be inserted inside grass catcher containers for ease of debris disposal. To remove the plastic trash bags when full:

a.Disengage blades, shift into neutral, engage the parking brake and stop the engine.

b.Raise seat. Unlatch and raise cover.

c.Remove one container at a time by grasping contai- ner handles and pulling toward the rear, off of the tube rails.

d.With the container resting on the ground, close and secure the top of the plastic lawn bag.

e.Tip the container on its side and slide the filled bag from the container.

f.Install a new plastic lawn bag with the edges of the bag draped over upper lip of the Container (for replacement bags refer to REPLACEMENT PARTS).

g.Repeat for other container.

h.Reinstall containers making sure right container overlaps left container at center support.

j.Close cover and secure latch over center support tube.

Avoid cutting wet grass or in the morning while the dew is still heavy. Grass clippings collected under these conditions tend to be sticky and adhere to the walls of the flow path causing clogging.

Your bagger is equipped with a dump bag indicator. As the bags become full, the flow indicating ball will drop down in its slot, indicating that the bags are full or the chutes have become clogged. Care should be taken not to damage the parts and that the ball moves freely at the beginning of each use.

If the grass catcher fails to pick up cut grass or leaves, it is an indication that clogging has occurred in the system or that the grass catcher containers are full.

a.Disengage blades, shift into neutral, engage the parking brake and stop the engine.

-Raise seat. Unlatch and raise cover.

-Slide out containers and dispose of clippings .

-Replace containers, close cover, and latch.

b.Unlatch chutes and check for clogging

-Remove all debris in chutes.

-Reassemble and latch chutes

c.Check to insure dump bag indicator has not become clogged.

-The air passage hole must be clear of debris. Gently insert a small twig or wire into passage- way to clear.

CAUTION

Do not operate mower with grass catcher partially installed.

Disengage blades and stop engine before leaving tractor seat to empty containers, unclog- ging chutes, etc.

Close cover before starting.

Disengage mower when crossing driveways or gravel surfaces and other areas where thrown objects could be a hazard.

Do not attempt to vacuum up cans or other potentially hazardous projectiles.

11

Page 11
Image 11
Husqvarna C42C owner manual Tips For Improved Bagging Operation