ASSEMBLY
1 | REAR MOUNTING BRACKET |
(See Figs. 1A, 1B & 1C) |
NOTE: If your tractor already has four (4) shoulder bolts installed on the rear drawbar, simply hang the mounting bracket, lanced tabs towards bottom, on the bolts. Discard hardware group "A" and disregard the remaining Step 1 instructions.
SHOULDER
BOLTS
LANCED TABS
TOWARD BOTTOM
FIG. 1A
If your tractor does not have four (4) shoulder bolts installed on the drawbar, follow the instructions below.
Use Hardware - - GROUP "A"
Only one set of hardware in GROUP "A" will be used to mount the rear mounting bracket. To determine which set is correct for your tractor, check to see if there are (2) two upper corner ribs on each side of drawbar. If your tractor has the upper corner ribs, use the (4) four self tapping shoulder bolts. If your tractor does not have the corner ribs, use the set of (4) four bolts and locknuts.
SELF TAPPING SHOULDER BOLTS (See Fig. 1B)
1.Using the four formed holes in the drawbar, install the four shoulder bolts as shown and tighten securely.
2.Hang the mounting bracket, lanced tabs towards bottom, on the bolts.
BOLTS
LOCKNUTS
| LANCED TABS |
| TOWARD BOTTOM |
| FIG. 1C |
2 | COVER SEAL (See Fig. 2) |
No hardware required |
1.Align mark on seal with mark at cover opening.
2.Work seal into opening so cover sits between flanges of seal.
ALIGNMENT
MARKS
|
| COVER SEAL |
|
| FIG. 2 |
|
|
|
|
|
|
3 | SUPPORT POST (See Fig. 3) | |
Use Hardware - - GROUP "B" | ||
|
| CAUTION: Container support is spring |
|
| loaded and locked to the cover. Handle |
UPPER CORNER RIBS
SELF
TAPPING
SHOULDER
BOLTS
UPPER CORNER RIBS
cover assembly carefully so as not to |
unlatch the cover from the container |
support. |
1.Rotate cover assembly onto its side as shown.
2.Assemble support post to container support with the three (3) carriage bolts and locknuts. Tighten securely.
CARRIAGE
BOLTS
LANCED TABS
TOWARD BOTTOM
FIG. 1B
BOLTS AND LOCKNUTS (See Fig. 1C)
1.Assemble the mounting bracket, lanced tabs towards bottom, using the four smaller inside holes on the drawbar.
2.Install the four bolts and locknuts as shown and tighten
securely.7
SUPPORT
POST
LOCKNUTS
FIG. 3
