ASSEMBLY
6 | CONTAINER MOUNTING (See Fig. 7) |
No hardware required |
•Install one container to left side first with warning to outside of unit. Install another container to center position and one in right position.
NOTE: Right container should always overlap left container at center supports.
•Close cover and lock latch handles over center support tubes.
COVER LATCH
HANDLES
CONTAINER
WARNING
CENTER
SUPPORT
TUBES
WAR | NING |
LOWER CHUTE (See Fig. 8 & 9)
7 Use Hardware - - GROUP "D"
•Press weld nut into rubber latch and install two latch hook assemblies to lower chute using screw, washer, and lock washer as shown.
•Tighten hardware securely.
•Raise and hold deflector shield in upright position.
•Place rear of chute over rear of mower deck opening. Push chute down and forward to guide extended edge of chute between discharge guard and mower deck.
•Hook front latch into tab hole on front of mower deck.
•Hook rear latch into flange hole on back of mower deck.
CAUTION: Do not remove discharge guard from mower. Raise and hold guard when attaching lower chute and allow it to rest on chute while in operation.
LOCK WASHER
SCREW
WAR | NING |
|
CONTAINER
HANDLECONTAINER WARNING
Fig. 7
WASHER
9
LATCH
WELD NUT
Fig. 8
DEFLECTOR
SHIELD
F R O N T
LATCH
REAR LATCH
Fig. 9
