ASSEMBLY
8 | CHUTE LATCH ASSEMBLY |
(See Fig. 10) |
Use Hardware - - GROUP "E & F"
•Assemble hardware shown (latch pin) to upper chute.
•Press weld nut into rubber latch and assemble rubber latch to lower chute, as shown.
•Tighten all hardware securely.
9 | UPPER CHUTE (See Fig. 11 &12) |
No hardware required |
•Lower mower deck to its lowest cutting position.
•Assemble upper chute by inserting curved end into hole in back of cover.
NOTE: Handle carefully so as not to damage full bagger
#10 x
UPPER CHUTE
#10 x 5/8"
SCREW
LOWER CHUTE
WASHER
3/16 x 3/4 x 16 GA.
WASHERS
3/16 x 3/4 x 16 GA.
SPLIT
SPACER
ACORN NUT
RUBBER
LATCH
WELD
NUT
indicator.
•Push in and turn upper chute until it is in line with lower chute.
•Align the bosses on lower chute with alignment slots on upper chute and slide together.
•Secure with rubber latch by hooking hole in latch over
latch pin.
FULL BAGGER
UPPER INDICATOR HANDLE
CHUTE
COVER
LOWER
CHUTE
LOCK WASHER
Fig. 10
Fig. 11
ALIGNMENT
SLOT
LATCH PIN
RUBBER
LATCH
BOSSES
Fig. 12
10 LEVEL MOWER DECK No hardware required
•Be sure deck is properly leveled for best mower perfor- mance. See your tractors owner's manual for instruc- tions
10
