To Replace Headlight Bulb, To Replace Fuse | Husqvarna CTH180 XP

SERVICE AND ADJUSTMENTS

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 35)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT WIRE

CONNECTOR

02141

FIG. 35

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is necessary, see engine manual.

TO ADJUST CARBURETOR

The carburetor has been preset at the factory and adjustment should not be necessary. However, minor adjustment may be required to compensate for differences in fuel, temperature, altitude or load. If the carburetor does need adjustment, see engine manual.

27

Image 27

Husqvarna CTH180 XP To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse, To Adjust Throttle Control Cable

Contents

CTH180 XP Safety Rules Safety Rules Table of Contents Steering Wheel Seat Unassembled Parts To Remove Tractor from CAR- TON AssemblyTools Required for Assembly HOW to SET UP Your Tractor Install Seat See Fig To Assemble Bagger See Figs To Install Bagger Components to Tractor See Figs A-4D Vertical Adjustment To Assemble and Install Mulcher Plug See FigBagger Adjustment See Fig Horizontal Adjustment Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL Belts Operation Know Your Tractor HOW to USE Your Tractor To Transport See Figs To Adjust Gauge Wheels See FigTo Operate Mower See Fig To Operate on Hills To Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD Gasoline Mulching Mowing Tips Mowing Tips To Dump Bagger See Bagging SeeTo Convert Mower See Before Each USE MaintenanceLubrication Chart General Recommendations Blade Care Tractor Engine Cleaning Service and Adjustments To Install Mower See FigTo Remove Mower See Fig FRONT-TO-BACK Adjustment See Figs To Level Mower Housing To Replace Mower Blade Drive Belt See Fig To Check and Adjust Brake See Fig To Replace Motion Drive Belt See Fig Transmission REMOVAL/REPLACEMENTTransaxle Motion Control Lever Neutral ADJUSTMENTSee Fig To Adjust Steering Wheel Alignment To Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See Fig Interlocks and Relays To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight Bulb Engine OIL StorageOther Fuel System Troubleshooting Points With attachment clutch TRACTOR- -MODEL NO. CTH180 XP HAUCT18H42C, Product no 17 Schematic Electrical KEY Part Description 259 258 Chassis and Enclosures Drive Repair Parts Steering Assembly 532 16 Steering Wheel 532 18 Seat Seat Assembly Wheels & Tires Decals Engine 532 17 Control Throttle Mower Lift 532 15 94-61 Washer Asm Inner Spring W/Plunger Mower Repair Parts Bagger Warranty Statement Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation 532 18 99-50 Rev 4.03.04 TR/MH