Husqvarna CTH2036T manual To Install Bagger Components to Tractor See Figs

ASSEMBLY

SEAT	SHOULDER
	BOLT
SEAT PAN
66
24
FLAT WASHER
02464
ADJUSTMENT
KNOB

Fig. 3

•Pivot seat and pan forward and assemble adjustment knob and flat washer loosely. Do not tighten.

Lower seat into operating position and sit on seat.

•Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.

•Get off seat without moving its adjusted position.

•Raise seat and tighten adjustment knob securely.

NOTE: You may now roll your tractor off the skid. Follow the instructions below to remove the tractor from the skid.

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)

•Raise attachment lift lever to its highest position.

•Releaseparkingbrakebydepressingclutch/brakepedal.

•Place freewheel control in "transmission disengaged" position (See “TO TRANSPORT” in the Operation section of this manual).

•Roll tractor forward off skid.

•Remove banding holding the deflector shield up against tractor.

Continue with the instructions that follow.

TO INSTALL BAGGER COMPONENTS TO TRACTOR (See Figs. 4-7)

•Remove discharge chute from rear of tractor. Unhook the two (2) straps and pull chute out and away from tractor.

•Remove the two (2) 3/8 nuts and flat washers from the bolts at the tractor back plate.

DISCHARGE

CHUTE

3/8 NUT

FLATWASHER

0227 7

Fig. 4

•Using the nuts and flat washers removed from tractor back plate, install the bagger support tube to the back plate as shown. Tighten securely.

SUPPORT

TUBE

FLAT

WASHER

3/8 NUT

BOLT 02330

Fig. 5

•Install the two upper support brackets through the back plate and to the chassis, install the clevis pin 3/8 x 11/16 and secure with retainer spring.

•Assemble both support brackets to the outside of the baggger support tube install the clevis pin 3/8 x 2 and secure with retainer spring.

•Replace discharge chute into rear opening of tractor.

Secure the chute with the two hook straps.

NOTE: The strap hook must go through the discharge chute only. Do not allow the hook to enter the slot in the tractor back plate. This will allow the discharge chute to float with the mower deck when moving on uneven terrain.

7