SAFETY INSTRUCTIONS
Use and care
•Never use a machine that is faulty. Carry out the checks, maintenance and service instructions described in this manual. Some maintenance and service measures must be carried out by trained and qualified specialists. See instructions under the heading Maintenance.
•Inspection and/or maintenance should be carried out with the motor switched off and the plug disconnected.
•Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired.
•Never use a machine that has been modified in any way from its original specification.
•Do not overload the machine. Overloading can damage the machine.
•Keep tools sharp and clean in order to enable safer work.
•Keep all parts in good working order and ensure that all fixtures are properly tightened.
Transport and storage
•Do not store or transport the drilling machine with the drill bit fitted in order to protect your drilling machine and drill bits from damage.
•Store the drilling machine in a lockable area so that it is out of reach of children and unauthorised persons.
•Store the drilling machine and stand in dry and frost free conditions.
General working instructions
WARNING! This section takes up the basic
!safety precautions for working with the drilling machine. This information is never a substitute for professional skills and experience. If you encounter a situation where you are uncertain how to proceed you should ask an expert. Contact your dealer, service agent or an experienced drilling machine user. Do not attempt any task that you feel unsure of!
•The machine has a very high torque. This demands good concentration during work, as serious personal injuries can occur if the drill bit suddenly jams.
•Keep your hands at a safe distance from the drill spindle and drill bit when the machine is running.
•Keep an eye open for oil or water leakage. If water or oil trickles out from the leakage hole on the top of the pinion neck, the seals must be replaced.
Stand drilling
•The machine is intended for stand mounted drilling.
•The following Husqvarna drill stands are recommended for use with the drill motor:
-DS 50 AT/ATS/Gyro/COMBO/BASIC
-DS 70 AT/ATS
-DS 450 ATS
•Make sure that the stand is secured correctly.
•Make sure that the drilling machine is secured correctly in the stand.
Drilling outdoors
•Always use extension cables that are approved for outdoor use.
Drilling in ceilings and the like
•Use a water collector to avoid water penetrating into the machine.
8 – English
