Husqvarna EZ4824K / 965880301, EZ6124 / 965880701 manual Manual Transport, ZT-2800 Bypass Linkages

operation

Manual Transport

ZT-2800 Bypass Linkages

When pushing or pulling the mower, engage the ZT-2800 (Integrated Zeroturn Transaxle) bypass linkages. The ZT-2800 bypass linkages are located on the rear of the frame, below the rear engine guard.

1.Raise the deck into the highest cutting position.

2.Pull the ZT-2800 bypass linkages up and out of the keyhole slots. Release the levers with the head outside the frame and held in the bypass position.

3.To reengage the ZT-2800 to drive, reverse the above procedure.

Load the machine into truck or trailer by driving up ramps in low gear. DO NOT LIFT! The machine is not intended to be lifted by hand.

WARNING!

Make no adjustments without:

•the engine stopped,

•the ignition key removed,

•the parking brake activated

Pump Release Valves

Pump release valves are located at the left and right of the pump. They are used to release the system so the machine may be moved by hand when not running.

Tilt seat forward to gain access to the pump. The left bypass valve sits directly opposite the right valve. It is not visible in the illustration.

Use a 17 mm open end wrench or socket and ratchet. Turn the outer locknut 2-3 turns. Using an 8mm wrench or socket, turn the inner nut one turn.

Reverse the procedure to reset the pump, makng sure the outer locknut is tightened.

IMPORTANT INFORMATION Tighten the valve moderately.

Do not overtighten the valve when closing. That can damage the valve seat.

8058-032

Bypass linkage, ZT-2800 engaged

8058-032

Bypass linkage, ZT-2800 locked in the bypass position

8011-507

Pump release valve - right

Husqvarna-33