ASSEMBLY
Fitting the hand guard and loop handle
1.Loosen the clutch sleeve’s two mounting bolts and dismantle the clutch sleeve.
2. Assemble the hand guard and loop handle by screwing them together. Take care to align the holes in both parts.
3. Slide the loop handle and the hand guard onto the shaft.
4. Slide the spacer into the slot in the loop handle.
5. Fit the nut and bolt. Do not
6. Adjust to give a comfortable working position. Tighten the nut. NOTE! The loop handle and hand guard must not be fitted behind the arrow marked on the shaft.
7.Fit the clutch sleeve and tighten the two mounting bolts.
Fitting the cutting attachment
Lay the hedge trimmer on a flat surface before fitting the cutting attachment. Otherwise the cutting attachment may not be fitted straight.
1. Fit the cutting attachment to the shaft.
NOTE! Make sure the drive shaft on the shaft is aligned with the
2.Tighten the lower screw, followed by the upper screw.
START AND STOP
Control before starting
•Inspect the working area. Remove objects that can be thrown.
• Check the blades. Never |
|
use blades that are dull, | A |
cracked or damaged. |
•Check that the hedge
trimmer is in full |
|
working order. Check |
|
that all nuts and bolts are | B |
tightened correctly. |
•Check that the blade guard is not damaged or distorted.
•Replace the blade guard if it is bent or damaged.
•Make sure the gearbox is lubricated correctly. See the section ”Lubricating the blades”.
•Ensure the blades always stop when the engine is idling.
•Only use the machine for what it is intended for.
•Ensure that the handle and safety functions are in order. Never use a machine that lacks a part or has been modified outside of the specifications.
8 – English
