Husqvarna J123L Technical Data, Control before starting, Cutting attachment guard Art No

EN START AND STOP

Control before starting

For reasons of safety follow these recommendations!

• Check the blade to ensure that no cracks have formed at the bottom of the teeth or by the centre hole. The most common reason why cracks are formed is that sharp corners have been formed at the bottom of the teeth while sharpening or that the blade has been used with dull teeth. Discard a blade if cracks are found.

• Check that the support flange is not cracked due to fatigue or due to being tightened too much. Discard the support flange if it is cracked.

• Ensure the locking nut has

not lost its captive force. The nut lock should have a locking force of at least 1.5 Nm. The tightening torque of the locking nut should be 35-50 Nm.

•Check that the guard is not damaged or cracked. Replace the guard if it is exposed to impact or is cracked.

•Check that the trimmer head and spray guard are not damaged or cracked.

Replace the trimmer head or spray guard if they are exposed to impact or are cracked.

•Never use the machine without a guard or spray guard nor with a defective guard.

TECHNICAL DATA

Approved accessories J-handle Type Centre hole in blades Ø 25,4 mm (1")

Threaded blade axle M10

Cutting attachment guard Art No.

Grass blade	Grass 255-4 1" (Ø 255 4-teeth)	503 93 42-02
Plastic knives	Tricut Ø 300	503 93 42-02
Trimmer head	S35	503 93 42-02
	T35	503 93 42-02
	Superauto II 1"	503 93 42-02
	Trimmy Fix	503 93 42-02
Support cup	Fixed	-

6 – English