MAINTENANCE
•Pull out the cord approx. 30 cm (12 inches) and hook it into the notch in the rim of the pulley. Release the recoil spring by letting the pulley rotate slowly backwards.
•Remove any remnants of the old starter cord and check that the return spring works. Insert the new starter cord through the hole in the starter housing and in the cord pulley.
•Secure the starter cord around the cord pulley as illustrated. Tighten the fastening well and ensure that the free end is as short as possible. Secure the end of the starter cord in the starter handle.
•Guide the cord through the
•Now pull the starter handle and in doing so tension the spring. Repeat the procedure once more, but this time with four turns.
•Note that the starter handle is drawn to its correct home position after tensioning the spring.
•Check that the spring is not drawn to its end position by pulling out the starter line fully. Slow the starter pulley with your thumb and check that you can turn the pulley at least a further half turn.
Tensioning the recoil spring
•Hook the starter cord in the notch in the pulley and turn the starter pulley about 2 turns clockwise.
CAUTION! Check that the pulley can be turned an additional 1/2 turn when the starter cord is pulled all the way out.
Changing a broken recoil spring
•Undo the bolt in the centre of the pulley and remove the pulley.
•Bear in mind that the return spring lies tensioned in the starter housing.
•Loosen the bolts holding the spring cassette.
•Remove the recoil spring by turning the starter over and loosen the hooks, with the help of a screwdriver. The hooks hold the return spring assembly on the starter.
•Lubricate the recoil spring with light oil. Fit the pulley and tension the recoil spring.
Fitting the starter
•To fit the starter, first pull out the starter cord and place the starter in position against the crankcase. Then slowly release the starter cord so that the pulley engages with the pawls.
•Fit and tighten the screws that hold the starter.
English – 19
