OPERATION
Rotate Pipe and repeat this cut- ting process until pipe circum- ference is cut.
Bevel Pipe: Position SpeedMill Bowl near end of pipe to be beveled. Accelerate power cut- ter to full throttle.
WARNING!
HOLD MACHINE ONLY at front and rear handles!
NEVER bevel or cut material while holding the pipe with your hands!
DO NOT use blade guard pivot handle as a hand hold while operating machine!
HOLD MACHINE ONLY at front and rear handles, as shown in the above photo.
Align proper SpeedMill Bowl with end of pipe, and move toward the pipe so that the pipe is slightly beveled.
Note: The bevel required is usually quite small, so do not remove excessive pipe mate- rial.
SpeedMill
