MAINTENANCE
MAINTENANCE:
CAUTION!
Allow SpeedMill Bowls to cool before performing any main- tenance.
NOTICE!
DO NOT hold SpeedMill Bowls using a screwdriver or other device through the slots in the bowl. Damage to the bowls or abrasive coating could occur.
DO NOT use a screw driver or similar in the slots of the SpeedMill Bowls to lock the blade. If you do it is likely the flanges will be damages and become unusable.
Use the proper procedure to lock the blade when at- taching or removing the blade or flanges – See below, or see K750 Operation Manual.
When removing the Hub nut, use a Screwdriver to lock the blade shaft in position. Push the screwdriver into the slot (see picture) and rotate the ar- bor until the screwdriver stops the rotation.
Inspect the SpeedMill Bowls
Always inspect the SpeedMill Bowls before you start cut- ting. Small nicks or scratches can be sanded smooth. If the SpeedMill Bowl has been bent or distorted in any way it must be replaced.
Cleaning
Plastic debris from a small- er flange often lodges itself in the bigger flange during cutting. This can easily be removed once the flanges have cooled down.
Use compressed air to blow shavings from Speed- Mill Bowl. DO NOT scrap shavings from bowl using a screwdriver or any other hard metallic tool. Damage to the bowls or abrasive coating could occur.
10 SpeedMill
CONVERTING THE SPEEDMILL TO A REGU- LAR POWER CUTTER.
The guard on the SpeedMill is designed to work together with the special outer flange and SpeedMill Bowls used on the SpeedMill. The 8” (200mm) SpeedMill Bowl must always be installed when the SpeedMill is used and the SpeedMill shall not be used for any other purpose than those mentioned in “USES” section of this document. Should you desire to convert the SpeedMill to a regular power cutter you must replace the cutting head with an original 12” or 14” cutting head attachment. We recom- mend you have an authorized dealer do the conversion.
WARNING!
NEVER use the SpeedMill as a regular power cutter!
SPARE PARTS:
The parts required for the SpeedMill Accessory are shown on the next page. For any other parts used on this ma- chine see the power cutter spare parts list (included).
