ASSEMBLY AND OPERATION
Mount the SpeedMill Bowl Assembly. Align the slot in the SpeedMill Hub with the face of the shaft. Make sure the flange face of the SpeedMill Hub con- tacts the face of the blade.
Install the blade shaft bolt into the Hub Assembly.
Using Combination Spanner, Supplied with machine, tighten blade shaft bolt by turning it clockwise. Torque to
Before using the assem- bled machine, completely read the power cutter op- eration manual supplied with this machine.
SpeedMill
OPERATION:
WARNING!
Before starting up machine make sure you completely read these instructions and the power cutter operation manual. Be familiar with operation of the machine before operation!
WARNING!
EVACUATE PIPE CONTENTS before cutting; else EXPLOSION may occur! Static electricity from cut- ting operation may cause gas or other pipe contents to explode (for installed piping).
Position plastic pipe so pipe end is off the ground. Secure pipe in place if required. Example: Set plastic pipe between two of the boards of a wooden pallet.
Before starting machine, verify that when SpeedMill Bowl and blade is positioned to cut / bevel the plastic pipe, that it clears all objects in the cutting area.
Start machine per instructions in K750
Power Cutter Operation Manual.
Position machine at top of plas- tic pipe to begin cutting through the pipe wall.
Move saw forward while maintaining a “square cut” on the end of the pipe. This means the cut should al- ways be perpendicular to the length of the pipe.
