4 ASSEMBLY GUIDE | GRILL CART Assembly | |
|
|
|
PartQty
A1– Cart RH Side Fascia 1
A2– Cart LH Side Fascia | 1 |
A3– Cart Base | 1 |
A4– Cart Foot | 2 |
A5– Wheels | 2 |
Fasteners
#10x3/4" | Wheel Retaining | Axle Rod | |
screw | Clip | ||
(qty 14) | (qty 2) | ||
(qty 2) |
Step 1: Assemble the LH and RH Side Fascia (A1 & A2) to the Cart Base (A3) by aligning screw holes in the fascias with corresponding holes in the cart base. Secure with 7 each, #10x3/4 screws (7 per side) using a phillips screwdriver. Repeat for other side. NOTE: The lift handles are shown in the up position. You can complete steps 1 and 2 with the handles lowered if desired.
A1
A2
A3
Step 2: Carefully place the cart assembly on its
back. Install the Cart Feet (A4) by
threading them into the bushings as shown.
Securely tighten the cart feet.
A4
A3
Step 3: Assemble the Wheels (A5) to the Cart Base (A3) by first sliding an axle rod through the wheel, then sliding the axle rod through the axle rod holes in the cart base. Secure with a wheel retaining clip. Repeat for the other side.
Axle Hole
A3
Axle Rod
Clip shown properly installed.
A5
Wheel Retaining Clip - install after placing wheel and axle rod through axle hole.
Wheel retaining clip -
Install after wheel and axle rod through the hole as shown in this direction only.
