![](/images/new-backgrounds/1297924/2979249x1.webp)
Assembly: Parts Identifier
The Ironman Quest Treadmill will require assembly before operating. Place unopened box on a clean, level surface. After opening the box, remove any packing material from the treadmill.
Do not throw away any packing materials until the unit is working properly. Do not remove unit from box until it has been fully assembled.
Make sure the electrical cord will easily reach an electrical outlet.
If at anytime you need assistance with assembly, call
Locate the hardware pack and identify the following parts required for assembly.
Tools:
1.Allen Wrench- 3/16”
2.Allen Wrench- 7/32”
3.Phillips Screwdriver
ALLEN BOLT M8*30 | 2 PCS |
| ||
ALLEN BOLT | M8*20 | 2 PCS |
| |
ALLEN BOLT | M8*15 | 4 PCS | WASHER Φ9*Φ22*2 | |
8 PCS | ||||
|
|
|
LEFT OUTSIDE FENDER
| PHILLIPS SCREWS |
| |
LEFT INSIDE FENDER | ST4.2*16 22 PCS |
| |
SCREW | |||
| |||
| DRIVER | WRENCH |
| LEFT OUTSIDE | LEFT UPPER | LEFT LOWER |
RIGHT INSIDE FENDER | HANDLE COVER | HANDLE COVER | HANDLE COVER |
| RIGHT OUTSIDE | RIGHT UPPER | RIGHT LOWER |
RIGHT OUTSIDE FENDER | HANDLE COVER | HANDLE COVER | HANDLE COVER |