02966
A | A |
4.If adjustment is necessary, see steps 2 and 3 in Visual Adjustment instructions above.
5.Recheck measurements, adjust if nec- essary until both sides are equal.
To obtain the best cutting results, the mower blades should be adjusted so the front tip is 1/8" to 1/2" lower than the rear tip when the mower is in its highest posi- tion.
CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.
•Raise mower to highest position.
•Position any blade so the tip is pointing straight forward. Measure distance (B) to the ground at front and rear tip of the blade.
02548
BB
•If front tip of blade is not 1/8" to 1/2" lower than the rear tip, go to the front of tractor.
•With an 11/16" or adjustable wrench, loosen jam nut A several turns to clear adjustment nut B.
•With a 3/4" or adjustable wrench, turn front link adjustment nut (B) clockwise (tighten) to raise the front of mower, or, counterclockwise (loosen) to lower the front mower.
B
A
Tighten adjust nut | Loosen adjust nut |
B to raise mower | B to lower mower |
02950
Loosen jam nut A first
NOTE: Each full turn of the adjustment nut will change mower height about 1/8".
•Recheck measurements, adjust if nec- essary until front tip of blade is 1/8" to 1/2" lower than the rear tip.
•Hold adjustment nut in position with wrench and tighten jam nut securely against adjustment nut.
TO REPLACE MOWER DRIVE BELT
MOWER DRIVE BELT REMOVAL
1.Park tractor on a level surface. Engage parking brake.
2.Lower attachment lift lever to its lowest position.
3.Disengage belt tension rod (K) from
lock bracket (L).
CAUTION: Belt tension rod is spring loaded. Have a firm grip on rod and re- lease slowly.
4.Remove screws (P) from R.H. and L.H. mandrel covers and remove covers
(Q).
23
