Husqvarna LOGTH2448T Troubleshooting Chart, Problem, Cause, Correction, Will not start, turn over

TROUBLESHOOTING CHART:

See appropriate section in manual unless directed to a service center

PROBLEM	CAUSE		CORRECTION
Will not start	1.	Out of fuel.	1.	Fill fuel tank.
	2.	Engine not “CHOKED”	2.	See “TO START ENGINE” in
		properly.		Operation section.
	3.	Engine flooded.	3.	Wait several minutes before
				attempting to start.
	4.	Bad spark plug.	4.	Replace spark plug.
	5.	Weak or dead battery.	5.	Recharge or replace battery.
	6.	Dirty air filter.	6.	Clean/replace air filter.
	7.	Dirty fuel filter.	7.	Replace fuel filter.
	8.	Water in fuel.	8.	Empty fuel tank and carbure-
				tor, refill tank with fresh gas-
				oline and replace fuel filter.
	9.	Loose or damaged wiring.	9.	Check all wiring.
	10. Carburetor out of adjustment.		10. See “To Adjust Carburetor”
				in Service and Adjustments
				section.
	11. Engine valves out of		11. Contact a qualified service
		adjustment.	center.
Hard to start	1.	Dirty air filter.	1.	Clean/replace air filter.
	2.	Bad spark plug.	2.	Replace spark plug.
	3.	Weak or dead battery.	3.	Recharge or replace battery.
	4.	Dirty fuel filter.	4.	Replace fuel filter.
	5.	Stale or dirty fuel.	5.	Empty fuel tank and refill tank
				with fresh, clean gasoline.
	6.	Loose or damaged wiring.	6.	Check all wiring.
	7.	Carburetor out of adjustment.	7.	See “To Adjust Carburetor” in
				Service and Adjustments
				section.
	8.	Engine valves out of	8.	Contact a qualified service
		adjustment.		center.
Engine will not	1.	Brake pedal not depressed.	1.	Depress brake pedal.
turn over	2.	Attachment clutch is engaged.	2.	Disengage attachment clutch.
	3.	Weak or dead battery.	3.	Recharge or replace battery.
	4.	Blown fuse.	4.	Replace fuse.
	5.	Corroded battery terminals.	5.	Clean battery terminals.
	6.	Loose or damaged wiring.	6.	Check all wiring.
	7.	Faulty ignition switch.	7.	Check/replace ignition switch.
	8.	Faulty solenoid or starter.	8.	Check/replace solenoid or
				starter.
	9.	Faulty operator presence	9.	Contact a qualified service
		switch(es).		center.
Engine clicks but	1.	Weak or dead battery.	1.	Recharge or replace battery.
will not start	2.	Corroded battery terminals.	2.	Clean battery terminals.
	3.	Loose or damaged wiring.	3.	Check all wiring.
	4.	Faulty solenoid or starter.	4.	Check/replace solenoid or
				starter.
Loss of power	1.	Cutting too much grass/too	1.	Raise cutting height/reduce
		fast.		speed.
	2.	Throttle in “CHOKE” position.	2.	Adjust throttle control.
	3.	Build-up of grass, leaves and	3.	Clean underside of mower
		trash under mower.		housing.
	4.	Dirty air filter.	4.	Clean/replace air filter.
	5.	Low oil level/dirty oil.	5.	Check oil level/change oil.

28