Husqvarna LR122 How To Set Up Your Tractor, CHECK BATTERY See Fig, INSTALL SEAT See Fig, Assembly

ASSEMBLY

HOW TO SET UP YOUR TRACTOR

CHECK BATTERY (See Fig. 2)

•Lift seat pan to raised position and open battery box door.

•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in CUSTOMER RESPONSIBILITIES section of this manual for charging instructions).

SEAT PAN

LABEL

BATTERY

BOX DOOR

TERMINAL TERMINAL

FIG. 2

INSTALL SEAT (See Fig. 3)

Adjust seat before tightening adjustment bolt or optional knob.

•Remove cardboard packing on seat pan.

•Place seat on pan and assemble shoulder bolt.

•Assemble loosely adjustment bolt, lock washer and flat washer (or knob, if so equipped). Do not tighten.

•Tighten shoulder bolt securely.

•Lower seat into operating position and sit on seat.

•Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down (See Fig. 6).

•Get off seat without moving its adjusted position.

•Raise seat and tighten adjustment bolt or knob se- curely.

SEAT

SEAT PAN

SHOULDER

BOLT

LOCK

WASHER

ADJUSTMENT		FLAT
BOLT
	KNOB	WASHER
	(IF SO EQUPPED)

FIG. 3

TO INSTALL MULCHER PLATE

PREPARE MOWER DECK (See Fig. 4)

•Using holes provided in mower deck, install 5/16-18x1 hex bolts, 5/16-18 locknuts, and 5/16-18 acorn nuts.

•Install hex bolt from under mower deck and tighten locknut securely. Assemble and tighten acorn nut on hex bolt.

ACORN NUT

ACORN NUT

LOCKNUT

LOCKNUT

HEX BOLT

FIG. 4

INSTALL MULCHER PLATE (See Figs. 5 and 6)

•Install two latch hooks to mulcher plate using screw, washer, lock washer, and weld nut as shown.

NOTE: Pre-assemble weld nut to latch hook by inserting weld nut from the top with hook pointing down.

•Tighten hardware securely.

•Raise and hold deflector shield in upright position.

•Place front of mulcher plate over front of mower deck opening and slide into place, as shown.

•Hook front latch hook onto hex bolt on front of mower deck.

•Hook rear latch hook onto hex bolt on back of mower deck.

	WELD NUT		HOOK
	FROM THE TOP
			POINTS
			DOWN
WELD	LOCK
	WASHER
NUT			LATCH
	SCREW		HOOK
LATCH
HOOK
WASHER
		LOCK	WELD
MULCHER		WASHER	NUT
PLATE		WASHER
		SCREW

FIG. 5

6