
SERVICE AND ADJUSTMENTS
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
•Depress clutch/brake pedal fully and set parking brake.
•Place gearshift lever in neutral (N) position.
•Place attachment clutch in “DISENGAGED” position.
•Turn ignition key “OFF” and remove key.
•Make sure the blades and all moving parts have completely stopped.
•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
TO REMOVE MOWER (See Fig. 18)
Mower will be easier to remove from the right side of tractor.
•Park tractor on a level surface and engage parking brake.
•Remove key from ignition.
•Be sure that attachment clutch lever is in “DISEN- GAGED” position.
•Lower mower deck to lowest cutting position.
•Remove retainer spring and washer that holds mower clutch spring to the mower clutch arm.
•Disconnect mower clutch spring from mower clutch arm.
•Remove retainer springs and washers from mower stabilizer link.
•Remove retainer springs and washers from rear lift links.
•Remove retainer spring and washer from front lift link.
•Withdraw front lift link, rear lift links and mower stabi- lizer link from brackets.
•Remove belt from engine pulley.
•Raise mower lift handle to transport position.
•Turn front tires to left.
•Slide mower deck out on right side of tractor.
TO INSTALL MOWER (See Fig. 18)
•Reverse removal instructions.
| ENGINE |
| |
| PULLEY | AXLE | |
| MOWER | BRACKET | |
MOWER | RETAINER | ||
CLUTCH | |||
CLUTCH | |||
ARM | SPRING | ||
SPRING | |||
|
| WASHER | |
BELT |
|
| |
|
| MOWER | |
|
| STABILIZER | |
|
| LINK | |
REAR LIFT |
|
| |
LINKS |
|
| |
FRONT LIFT LINK |
|
MOWER UPSTOP ADJUSTMENT (See Fig. 19)
•Raise attachment lift lever to highest (transport) posi- tion.
•Measure distance from top of mower deck to lower flange of chassis (dim. “A”).
•Dim. “A” should be
•To adjust dim. “A”, if required, lower mower to lowest position. Remove washer and retainer spring in trun- nion, then withdraw trunnion pin from bracket. Loosen trunnion locknut and rotate trunnion counterclockwise on lift link to increase dim. “A” or clockwise on lift link to decrease dim. “A”.
NOTE: Each full turn of trunnion will change dim. “A” by 1⁄16 inch.
•Tighten trunnion locknut.
•
•Raise lift lever to highest position and recheck dim. “A”. Repeat adjustment if necessary.
| LOWER FLANGE |
|
| OF CHASSIS |
|
“A” | TOP OF MOWER DECK | |
|
| |
RETAINER |
|
|
SPRING |
|
|
WASHER |
|
|
BRACKET |
|
|
FRONT LIFT TRUNNION | TRUNNION | |
LOCKNUT |
FIG. 19
FIG. 18 | 15 |