ASSEMBLY
7 | TRIMMING MIDDLE CHUTE | 9 | INSTALLING BAGGER MOUNT |
(42" and 48" decks only) | 2 Bin Collector |
1.Using the hacksaw, trim along the dashed line.
2.Locate the middle chute, fl at washer, hood latch, weld nut, lock washer and machine screw from kit.
3.Install in the appropriate hole at the upper end of the middle chute, according to deck size.
1.Remove the top right mount strap from the rear of the mower and save hardware.
2.Remove the right rear skid plate bolt and the lower right mount strap bolt from the mower and save hardware.
Machine Screw | 42/48 Trim Line |
| |
Hood Latch |
|
| Middle Chute |
Weld Nut
Lock washer
Flat Washer
52/61 Hole
42/48 Hole
8INSTALLING MIDDLE CHUTE
1.Place middle chute over the top end of the blower assembly.
2.Latch middle chute to blower assembly.
Blower Assembly
Middle Chute
Mount Strap
Remove
Skid Plate | Mount Strap |
3.Place the bagger mount bracket against the rear of the engine guard, reinstall the upper right mount strap and secure with 1" carriage bolts and previously removed nuts.
4.Tighten all hardware.
Carriage Bolts
Bagger Mount Bracket
11
