| ASSEMBLY |
3MOUNTING BLOWER ASSEMBLY | 4INSTALLING DRIVE BELT |
1.Position blower over the discharge tabs on the deck and set blower onto the deck.
2.Be sure the blower is sitting fl ush against the outside of the deck.
NOTE: The rear mount bracket is designed to fi t all deck sizes.
Rear Mount Bracket
52/61 Contact Area
42/48 Contact Area
1.Make sure the tension release lever is forward or disengaged.
2.Place the belt over the pulley on the deck. Refer to illustration for proper routing.
3.Move the tension release arm to the rear and engage in the latch.
Tension Release Arm | Outer Pulley |
|
Rear Of Deck
Twist in Belt
52/61 Contact Area
Idler Pulleys
3.Install the front mount bracket to the deck with the pin and hairpin cotter supplied with the kit.
Hairpin Cotter
Pin
Outer Pulley Cover
9
