CONTENTS
Contents
KEY TO SYMBOLS |
|
Symbols | 2 |
CONTENTS |
|
Contents | 3 |
Note the following before starting: | 3 |
SAFETY INSTRUCTIONS |
|
Cutting equipment | 4 |
Specification of bar and saw chain | 4 |
Sharpening your chain and adjusting raker clearance . 5
Tensioning the chain | 6 |
Lubricating cutting equipment | 7 |
Checking wear on cutting equipment | 8 |
Safety instructions for using a pruning saw | 8 |
WHAT IS WHAT? |
|
What is what on the saw attachment? (Saw attachment |
|
with shaft PA 1100) | 11 |
What is what on the saw attachment? (Saw attachment |
|
without shaft PA) | 12 |
ASSEMBLY |
|
Fitting the cutting head (Saw attachment with shaft PA |
|
1100) | 13 |
Fitting the cutting head (Saw attachment without shaft |
|
PA) | 13 |
Fitting the bar and chain | 13 |
Fitting the hanging ring | 13 |
Adjusting the harness | 14 |
Filling with oil | 14 |
Check before starting | 14 |
TECHNICAL DATA |
|
Technical data | 15 |
Bar and chain combinations | 15 |
16 |
Note the following before starting:
Husqvarna AB has a policy of continuous product development and therefore reserves the right to modify the design and appearance of products without prior notice.
Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.
These instructions supplement the instructions that were included with the machine. For other procedures, please refer to the operating instructions for the machine.
WARNING! Under no circumstances may the
!design of the machine be modified without the permission of the manufacturer. Always use genuine accessories.
WARNING! This accessory may only be used
!together with the intended clearing saw/ trimmer, see under heading ”Approved accessories” in chapter Technical data in the machine’s Operator’s Manual.
The machine is only designed for cutting branches and twigs.
English – 3
