Husqvarna SR600 Technical Data, Angle gear, Maintenance schedule, Technical data

MAINTENANCE

Angle gear

The angle gear is filled

a sufficient quantity of grease at the factory.

Normally, the grease does not need to be changed except when repairs are carried out.

Maintenance schedule

Below follows some general maintenance instructions. If you need further information please contact your service workshop.

Important information

The sweeper is often used under dusty conditions. It is extremely important to maintain the air filter regularly, often daily. The air filter must be oiled in order to work satisfactorily.

Daily maintenance

1.Oiling the air filter Always use

HUSQVARNA filter oil, order no. 503 47 73-01. The filter oil contains a solvent to make it spread evenly through the filter. You should therefore avoid skin contact. Put the filter in a plastic bag and then pour the filter oil over it. Knead the plastic bag to distribute the oil. Squeeze the excess oil out of the filter inside the plastic bag and pour off the excess before fitting the filter on the machine. Never use common engine oil. This would drain through the filter quite quickly and collect in the bottom.

2. Check that the sweeper

rollers do not rotate when the engine is idling.

3. Check that the sweeper rollers are not cracked or damaged. Replace the sweeper rollers if necessary.

TECHNICAL DATA

Technical data

Weight, Lbs/kg	5.2
Max. rpm	262 rpm/4.4 rps
Sweeper roller width	575 mm
Sweeper roller diameter	270 mm

8 – English