Service Notes | Husqvarna ST 324P specification

SERVICE NOTES

27

Image 27

Husqvarna ST 324P warranty Service Notes

Contents

Operator’s Manual Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Uhmw Skid Plates Parts Packed Separately in Carton Unfold Upper Handle Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Remove Snow Thrower from Carton Install Auger Control ROD See Figs Install Traction Drive Control ROD See Figs Install Discharge Chute / Chute Rotator Head See Fig Install Chute Deflector Remote Control See FigsCheck Tire Pressure Know Your Snow Thrower Operation Recoil auxiliary starter handle used for starting the engine Meets A.N.S.I. Safety Requirements Stopping HOW to USE Your Snow Thrower Using the CLEAN-OUT Tool See Fig To Throw Snow See FigTo Move Forward and Backward See Fig To Transport Before Starting the Engine Before Stopping To Start Engine If Recoil Starter has Frozen Snow Throwing Tips Lubrication MaintenanceGeneral Recommendations Before Each USE Engine Cleaning Shear Bolts See Fig Service and AdjustmentsTo Adjust Snow Thrower Height Chute Deflector To Replace Belts See Fig Carburetor To Adjust Cable Tension See FigTo Adjust Traction Belt and Auger Belt Tension To Remove Wheels See Fig Engine OIL StorageOther Fuel System Problem Cause Correction Troubleshooting Consumer Wheeled Products Limited Warranty HOW to Obtain Service Consumer Wheeled Limited Warranty Chart Armor Protected Stamped Deck Shell Example Below Service Notes Service Notes 06/17/2014 AP