Parts Packed Separately in Carton, Skid Plates | Husqvarna ST 330T

PARTS PACKED SEPARATELY IN CARTON

(1) RETAINER SPRINGS (169675)

	SAFTEY	(1) MULTI-	(1) WASHER 3/8	(1) LOCKNUT 3/8
		WRENCH
	IGNITION KEY (S)
			(19131316)	(73800600)
		(180684)
	(443059)

(6) SHEAR BOLTS 1/4-20 x 1-3/4		(6) LOCKNUTS
(6) SHEAR BOLTS 1/4-20 x 1-3/4		1/4-20
(585511801)		1/4-20
(585511801)		(73800400)	(2) FLAT WASHERS
		(73800400)

	SKID PLATES
			(2) CARRIAGE BOLTS	(1) LOCKNUT	(1) CARRIAGE BOLT
			3/8-16 x 2.25	5/16-18	5/16-18 x 5/8
				(751153)	(72250505)
	(4) LARGE FLANGE	(4) CARRIAGE BOLT
(2) SKID PLATE	NUT 5/16-18	5/16-18 x 1.00		(1) LOCKNUT	(1) SHOULDER
(583838801)	(585802801)	(437318)	(2) HANDLE KNOBS	1/4-20	BOLT 1/4-20	(1) SPRING
			(2) HANDLE KNOBS	(191730)	(179829)	(184505)
				(191730)	(179829)	(184505)

4

Image 4

Husqvarna ST 330T warranty Parts Packed Separately in Carton, Skid Plates

Contents

Operator’s Manual Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Parts Packed Separately in Carton Skid Plates Assembly / PRE-OPERATION HOW to SET UP Your Snow ThrowerRemove Snow Thrower from Carton Unfold Upper Handle Install Traction Drive Control ROD See Figs Install Auger Control ROD See Figs Install Chute Deflector Remote Control See Figs Install Discharge Chute / Chute Rotator Head See FigCheck Tire Pressure Operation Know Your Snow Thrower Meets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting the engine Transport and Height Adjustment of Snow Thrower SET Height Adjustment See FigsTo Transport See Figs Packed Snow Normal Operation Transport Float HOW to USE Your Snow Thrower Stopping To Throw Snow See Fig Using the CLEAN-OUT Tool See FigTo Move Forward and Backward See Fig Before Starting the Engine To Transport ADD Gasoline See Fig To Start EngineCold Start Electric Starter Warm Start Electric Starter Snow Throwing Tips Warm Start Recoil StarterBefore Stopping If Recoil Starter has Frozen Maintenance General RecommendationsBefore Each USE Lubrication Cleaning Engine Service and Adjustments To Adjust Snow Thrower HeightChute Deflector Shear Bolts See Fig To Replace Belts See Fig To Adjust Cable Tension See Fig To Adjust Traction Belt and Auger Belt TensionTo Remove Tracks See Fig Carburetor Instructions for Adjusting Power Steering Cables See Figs Storage OtherFuel System Engine OIL Troubleshooting Problem Cause Correction Consumer Wheeled Products Limited Warranty HOW to Obtain Service Consumer Wheeled Limited Warranty Chart Armor Protected Stamped Deck Shell Example Below 06/17/2014 TH