ASSEMBLY
Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes.
When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
•Cut along dashed lines on all four panels of carton. Remove end panels and lay side panels flat.
•Check for any additional loose parts or cartons and remove.
BEFORE REMOVING TRACTOR FROM SKID
CHECK BATTERY (See Fig. 2)
•Lift seat pan to raised position and open battery box door.
•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at
SEAT PAN
|
| LABEL |
DISCARD |
|
|
TERMINAL |
|
|
PROTECTIVE |
| |
CAPS |
| 02602 |
|
| |
TERMINAL |
| NUT |
|
| |
COVER |
|
|
|
| BOLT |
POSITIVE |
| NEGATIVE |
(RED) | 02604 | |
CABLE |
| (BLACK) |
|
| CABLE |
FIG. 1
ATTACH STEERING WHEEL (See Fig. 1)
ASSEMBLE EXTENSION SHAFT AND BOOT
•Slide extension shaft onto lower steering shaft.
•Place tabs of steering boot over tab slots in dash and push down to secure.
INSTALL STEERING WHEEL
•Position front wheels of the tractor so they are pointing straight forward.
•Remove steering wheel adapter from steering wheel and slide adapter onto steering shaft extension.
•Position steering wheel so cross bars are horizontal (left to right) and slide inside boot and onto adapter.
•Assemble large flat washer, 5/16 lock washer, 5/16 hex bolt and tighten securely.
•Snap steering wheel insert into center of steering wheel.
•Remove protective materials from tractor hood and grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO ROLL OFF SKID.
| INSERT |
| 5/16 HEX BOLT |
| 5/16 LOCK WASHER |
| LARGE FLAT WASHER |
| STEERING |
| WHEEL |
STEERING BOOT | ADAPTER |
| |
TABS | TAB |
| |
| SLOTS |
EXTENSION SHAFT |
|
LOWER STEERING SHAFT |
|
| 03125 |
FIG. 2
6
