Husqvarna XOUS2009 8INSTALLING CHUTE SUPPORT, 9INSTALLING WEIGHT KITS, 10MOUNTING COVER ASSEMBLY

	ASSEMBLY
8INSTALLING CHUTE SUPPORT	9INSTALLING WEIGHT KITS

1.Position upper chute support against bagger inlet, flush at outer edges. See Illustration.

2.Using support as a template, drill two 3/8 holes into bagger hood.

Upper Chute Support

Bagger Hood

1.Bolt cast weight to weight brackets using 3/8-16 x 3 bolts and four nuts.

2.Slide both weight brackets over the front tube on the frame. Be sure to position the weight assembly in the center of the frame.

3.Secure with 3/8-16 x 3½ bolts and four nuts.

Front Tube

Bagger Inlet

3.Secure upper chute support to hood with hex bolts, washers and nyloc nuts.

3" Bolt

Weight Assembly 3½ Bolt

Weight Bracket

Flex Trim

Nut Flat Washers

Hex Bolt

CAUTION

DO NOT operate mower with grass catcher without front weights installed.

10MOUNTING COVER ASSEMBLY

NOTE: Assistance from another person may ease mounting the cover assembly to mower.

1.Lift and rotate cover to align the cover brackets with support assembly tubes.

2.Slide the cover down over the support tubes until secure.

11