Husqvarna YT180 owner manual To Replace Fuse, To Replace Headlight Bulb, Interlocks And Relays

Models: YT180

1 48
Download 48 pages 19.51 Kb
Page 22
Image 22
TO REPLACE FUSE

SERVICE AND ADJUSTMENTS

TO REPLACE FUSE

Replace with 30 amp automotive-type plug-in fuse. The fuse holder is located in the engine compartment, directly in front of the dash.

TO REPLACE HEADLIGHT BULB

Raise hood.

Pull bulb holder out of the hole in the backside of the grill.

Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running or prevent it from starting.

Check wiring. See the electrical wiring diagram in the Repair Parts section of this manual.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 30)

Lift hood. Disconnect headlight wire connection.

Remove wing nuts on inside of side panels.

Pivot hood and side panel forward and lift off tractor.

To replace, reverse above procedure.

WINGNUT (INSIDE)

WIRE CONNECTION

FIG. 30

22

Page 22
Image 22
Husqvarna YT180 owner manual To Replace Fuse, To Replace Headlight Bulb, Interlocks And Relays, Service And Adjustments