STORAGE
When storing the unit at the end of the mowing season, the following steps should be taken to ensure readiness for the next mowing season.
1.Remove all grass, dirt, and trash from tractor and cutting units.
IMPORTANT: Wash the machine with a mild detergent and water. Do not pressure wash the machine. Avoid excessive use of water
Clean tractor and mower and touch up all scrapes with
2.Replace air filter element.
3.Check thoroughly for any worn or damaged parts that need replacing and order them from your dealer.
4.Block tractor up so weight is off tires. Check tire pressure and inflate to proper operating pressure.
NOTE: Do not deflate tires.
5.Perform separate engine and battery preparation as listed below.
6.Store tractor in a clean, dry place.
Preparation of engine for storage
When engine is to be unused for long periods, proceed as follows:
1.Run engine for a minimum of 15 minutes.
2.Drain oil from crankcase while engine is still warm.
3.Refill with fresh oil of proper viscosity.
4.Drain fuel tanks.
5.Remove and replace fuel filter.
6.Clean exterior surface of engine. Spread a light film of oil over any exposed metal surfaces of engine that are subject to corrosion.
7.Check oil filler cap and fuel tank cap to make certain they are securely in place.
Preparation of battery for storage
When the machine is to be unused for long periods, it is best to disconnect the batteries and remove them from the unit. At this time perform the following battery maintenance:
1.Remove the battery from machine
2.Clean battery, terminals and cable connectors
3.Charge the battery, if necessary
4.Store battery in a cool, dry place (do not expose to freezing temperatures)
5.Always keep the battery fully charged. (Especially
important to prevent battery damage when the temperature is below 32oF.)
New season preparation
Before starting the tractor following post season storage, the following servicing is required:
1.Clean tractor, removing trash and dirt accumulation.
2.Check engine oil, hydraulic oil and coolant levels.
3.Fill fuel tanks with fresh fuel. Bleed fuel system as outlined in Maintenance section. Run machine at half speed for 5 minutes, checking operation of steering control lever. Stop engine and check for oil leaks, loose fittings and so forth.
WARNING: At start of new season always check that fresh oil and coolant have been added to machine. If oil and coolant are drained at season’s end and not replaced, engine damage will result.
4.Tighten any bolts that have loosened and make sure all hair pins, cotter pins and clevis pins are in place.
5.Install all safety shields and review safety precautions listed in this manual.
6.Check and inflate tires to
7.Install fully charged batteries and attach the battery cables.
PRODUCT LITERATURE
If you would like to view or print a copy of the Hustler Z4 product manuals go online to www.hustlerturf.com and click on the MANUALS button.
602223_0609 |
