Hyundai H-CMD4015 instruction manual Disconnect the wire harness and the antenna

1.Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery's negative (-) terminal.

2.Disconnect the wire harness and the antenna.

3.Press RELEASE button to remove the control panel.

4.Lift the top of the outer trim ring then pull it out to remove

it.

5.Use the two supplied release keys to remove the unit from the mounting bracket. Insert the left ("L") and right ("R") release keys as far as they will go (with the notches facing up) into the appropriate slots at the middle left and right sides of the unit. Then slide the sleeve off the back.

6.Mount the sleeve by inserting the sleeve into the opening of the dashboard and bend out the tabs located around the sleeve with a screwdriver. Not all tabs will be able to make contact, so examine which ones will be most effective. To secure the sleeve in place, bend out the appropriate tabs so that they make contact with the dashboard.

7.Reconnect the wire harness and the antenna and be careful not to pinch any wires or cables.

8.Slide the unit into the sleeve until it locks into place.

6