Hyundai H-CMD4015 instruction manual Dismantling the unit

9.To further secure the unit, use the supplied metal strap to secure the back of the unit in place. Use the supplied hardware (Hex Nut (M5mm) and Spring Washer) to attach one end of the strap to the mounting bolt on the back of the unit. If necessary, bend the metal strap to fit your vehicle's mounting area. Then use the supplied hardware (Tapping Screw (5x25mm) and Plain Washer) to attach the other end of metal strap to a solid metal part of the vehicle under the dashboard. This metal strap also helps ensure proper electrical grounding of the unit. Ensure that you install the short part of the mounting bolt to the back of the unit and the other long part to the dashboard.

10.Reconnect the cable to the vehicle battery's negative (-) terminal. Then replace the outer trim ring and install the unit's front panel.

Dismantling the unit

1.Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery's negative (-) terminal.

2.Press RELEASE button to remove the front panel.

3.Lift the top of the outer trim ring then pull it out to remove it.

4.Insert both of the supplied keys into the slots at the middle left and right sides of the unit then pull the unit out of the dashboard.

5.Remove the metal strap attached to the back of the unit (if attached).

7