![](/images/new-backgrounds/1145063/14506331x1.webp)
Connecting to System
ida FS 250, Operator's Guide
Y37,n1 |
|
Write | Emulation |
3812 | *3812 / 5219 / 3816 |
5224 | 5224 |
5225 | 5225 |
5256 | 5256 |
4234 | 4234 |
*default value
SCS printers
Selecting emulation via the line
The default configuration of the ida FS 250 can be used for most application programs and uses. You should only change the address and the emulation. The rest of the settings should only be changed if you have special requirements.
3.3 Upgrading to IPDS
If you need to upgrade your ida FS 250 with the IPDS module, please follow these instruction before proceeding with the installation.
1.Unscrew the 4 screws from the bottom of the converter.
2.Place you hands on each side of the box, bottom facing down and the rear panel facing you. Carefully press open the top cover of the converter.
3.Place the IPDS module (main component side facing up) on the PCB of the box. Note that the connector has to be placed on top of the PCB’s connector (to the right on the PCB).
4.Make sure the plastic supports fit in the holes of the IPDS module.
5.Press the module gently into position and, while still facing the rear panel, place the top cover precisely above the bottom cover so that all edges are aligned. Press the top cover gently into a locked position.
6.
7.Now proceed to the actual installation of the converter to the printer and the system.