IBM 6331 user manual Install The Monitor, Power Cord

E-2

INSTALL THE

MONITOR

•To connect the tilt/swivel base to the monitor, align hooks with the sockets on the bottom side of the monitor, and gently push the base towards the front of the monitor.

•The 15-pin D-shell signal connector on the signal cable connects easily to the video adapter output on your computer. Lock both screws on the connector to ensure a firm connection.

•Turn the computer power switch to ON. Then turn the monitor power switch to ON by pressing the switch inward. The green power light-emitting diode (LED) will light.

•Allow about 30 seconds for the CRT tube to warm up. Data will display on the screen.

•If your display fails to function properly, refer to the “Troubleshooting” section in this manual.

POWER CORD

•Check first to make sure that the power cord you use is the correct type required for your area.

•This monitor has a universal power supply that allows operation in a 100/120 V ac or 220/240 V ac voltage area. No user-adjustment is required.

•First connect the power cord into your monitor power input socket, and then plug the other end into a 3-pin ac outlet. The power cord can be connected to a wall outlet or the power output socket on your computer, depending on the type of power cord supplied with your monitor.

•For units to be used at 120 V ac:

Use a UL-Listed Cord Set consisting of a minimum No. 18 AWG, Type SVT or SJT three- conductor that is 4.5 m (15 ft) long and a parallel blade, grounding-type attachment plug rated 10 A, 125 V.

•For units to be used at 240 V ac (domestic use): Use a UL-Listed Cord Set consisting of a minimum No. 18 AWG, Type SVT or SJT three- conductor cord a maximum of 4.5 m (15 ft) long and a tandem blade, grounding-type attachment plug rated 10 A, 250 V.

•For units to be used at 220/240 V ac (outside of the United States):

Use a Cord Set consisting of a mininum No.18 AWG cord and grounding-type attachment plug rated 15 A, 250 V. The cord set must have the appropriate safety approvals for the country in which the equipment will be installed and marked HAR.

113393-0A-E.pm6 2 8/1/00, 6:38 PM