Image setup for Windows 95, Windows 98, Windows NT, Windows 2000, Windows Me, or Windows XP
i If the monitor is in standby mode, it may automatically
turn off while you are waiting for it to warm up.
i The size and diversity of the dot pattern varies with the
screen resolution.
To set up the monitor automatically in Windows 95, Windows 98, Windows NT, Windows 2000, Windows Me, or Windows XP, do the following:
1. Turn on the monitor first; then turn on the computer.
If the message "Check Signal Cable" is displayed, or if nothing is displayed, check:
•That the video interface cable is not connected properly.
•The correct video adapter card is not installed.
•The correct supported display mode is selected for your computer.
2.Wait approximately 15 minutes for the monitor to warm up.
3.If the icon bar and tool bar are displayed, drag them to the bottom of the screen.
4.Insert the User's Guide and Installation Files CD into the computer's
5.Check the operating system installed on your computer and follow the instructions from the table below.
Operating system installation steps
Operating | Step 1 | Step 2 | Step 3 | |
System | ||||
|
|
| ||
|
|
|
| |
|
|
|
| |
Windows 95 | Open program manager |
|
| |
Windows 98, |
|
| Type e:\TESTPAT where e is | |
Windows 2000, |
| Select | ||
Select | the letter of your | |||
Windows NT, | RUN | |||
RUN | then press Enter. | |||
Windows Me or |
| |||
|
|
| ||
Windows XP |
|
|
| |
|
|
|
|
6.When the dot pattern appears, press the " 
" button at the bottom of the monitor. This activates the Image setup procedure, which will optimize the display settings with the provided
•The screen will momentarily turn black while auto adjustment proceeds. When finished, the Image setup message disappears and the screen returns to a normal display.
7.To clear the Image setup test pattern, press the Esc key on your keyboard.
You have completed the monitor setup for Windows. If you are using the DOS operating system, go to "Image setup for DOS on page" 15.
16
