Connecting the Monitor
Connect to an APPLE Macintosh System
Figure shows the connection to an Apple Macintosh, using a separately purchased adapter. For more information on adapter requirements, contact your IBM authorized dealer for PartNumber 96G2694.
1Power OFF both the monitor and the MAC.
2Locate the appropriate MAC to VGA adapter block at your local computer store. This adapter changes the high density 3 row 15 pin VGA connector to the correct 15 pin 2 row connection to mate with your MAC. Attach the other end of the signal cable to the side of the adapter block with 3 rows.
3Connect the attached adapter block/signal cable to the video output on your MAC.
4Connect the plug from the
unit. 1 Connect one end of the AC power cord into the
5Power ON the MAC, then the monitor.
6If you see the Check Signal Cable message, check the signal cable and connectors.
7After using the system, power OFF the monitor, then the MAC.
Note : If you see the “Outside Range Limits” message, check to make sure your system is set to one of the factory preset modes.(See pages A12 and A13)
Adapter 15P
1
3
Signal Cable
Power Cord
2
A4