2.Pivot the drive bay assembly upward to gain access to the cable connections.
3.Locate the power supply. See “Locating components” on page 2.
Note: Note the routing of the power supply cables. It is important to route the cables the same way when installing a new power supply assembly.
4.Disconnect the power cables from the hard disk drive and the
5.Disconnect the power cables P1 1and P2 2 from the system board.
6.Disconnect the wire from the internal speaker connector on the system board. See “Identifying parts on the system board” on page 3.
4Hardware Removal and Replacement Guide
