Installing memory
Your computer has two connectors for installing dual inline memory modules (DIMMs) that provide up to a maximum of 2 GB of system memory.
When installing memory, the following rules apply:
vUse 2.5 V,
vUse 128 MB, 256 MB, 512 MB, or 1 GB DIMMs (when available) in any combination.
Note: Only DDR SDRAM DIMMs can be used.
To install DIMMs:
1.Access the system board. See “Accessing system board components and drives” on page 12.
2.Locate the DIMM connectors. See “Identifying parts on the system board” on page 13.
3.Open the retaining clips.
4.Make sure the notch in the DIMM aligns with the tab on the connector. Push or insert the memory module straight down into the connector until the retaining clips close.
5.Replace the PCI riser and adapters if it was removed.
6.Place the drives back to the original position.
7.Replace the cover. See “Closing the cover and connecting the cables” on page 25.
14User Guide
