Completing the installation
After replacing the CRUs, you need to close the cover and reconnect cables, including telephone lines and power cords. Also, depending on the CRU that was replaced, you might need to confirm the updated information in the IBM Setup Utility program.
To complete the CRU installation:
1.Ensure that all components have been reassembled correctly and that no tools or loose screws are left inside your computer.
2.Clear any cables that might impede the replacement of the cover.
3.Make sure that the drive locks on the drive bay assembly are both in the locked position. Otherwise, you cannot close the cover.
4.Close the cover.
5.If a cover lock is installed, lock the cover.
6.If your computer is being placed in the vertical position, attach the floor stand.
Attention: To prevent overheating and possible component damage, always attach the floor stand when placing the computer in the vertical position.
7.Reconnect the external cables and power cords to the computer. See “Locating connectors on the rear of your computer” on page 9.
8.Turn on the computer. If you need to update the configuration, see Chapter 3, “Using the IBM Setup Utility,” on page 27.
9.Return the CRU that was replaced to IBM as per instructions from the IBM HelpCenter.
