IBM HH LTO manual Installation requirements, Installing the drive in IBM servers

Installation requirements

To install this drive, you must have the following:

vA dedicated low voltage differential (Ultra2) or a single-ended (SE)2 SCSI host adaptor

vDocumentation for your computer, SCSI bus adapter, or external enclosure

vAn Ultra2 LVD active terminator if you are installing the tape drive at the end of an Ultra2 LVD SCSI device chain3, or an SE active terminator if you are installing the tape drive at the end of an SE SCSI device chain

vPhillips and flat blade screwdrivers for the mounting screws, and for opening your computer

vFlat-nose pliers (optional) to install and remove jumpers

vAn available 5.25-inch half high drive bay

vSupported operating system, Windows NT, Windows 2000, Netware, or Linux

vSupported backup software, Veritas Backup Exec or CA AverServeit

Installing the drive

This section contains information on installing the tape drive in IBM servers and in other computers.

Installing the drive in IBM servers

The IBM 100/200 GB HH LTO Internal Tape Drive can be installed in IBM xSeries 200, 220, 230, 240, 340 as well as IBM Netfinity® 4500R, 5100, 5600, 7100, and 7600. It can also be installed externally via a 3551001, or a 3510020, to IBM xSeries 330 or Netfinity 6000R or 8500R. Refer to the documentation that comes with the server for instructions on installing the tape drive.

General installation instructions

Follow these steps to install the tape drive in other computers.

Step 1. Selecting a SCSI ID

Each device on a SCSI bus must have a unique SCSI ID. You can select a SCSI ID from 0 to 6 for the tape drive. The SCSI ID must be supported by your SCSI adapter. Refer to your SCSI adapter documentation for the range and relative priority of the IDs supported. The tape drive is shipped with the SCSI ID preset to 3.

Follow these guidelines to select a SCSI ID:

vAssign the tape drive to one of the higher priority IDs available (0–6).

vAssign the lower priority ID numbers (8-15) to those devices that are most often used or are faster than other devices in the chain.

vDo not assign an ID of 7, because this is usually used as the SCSI adapter ID.

Depending on your computer, there are several ways to view your current SCSI ID settings:

2.This tape drive can be installed on a single-ended (SE) SCSI device chain, but doing so might limit the performance of the drive.

3.SCSI termination might be provided with your computer or SCSI adapter. Refer to the documentation that comes with your computer or SCSI adapter for more information.

2100/200 GB HH LTO Internal Tape Drive: User’s Guide