3.Connect the power cord to the monitor and then plug the power cord into a properly grounded outlet. Next, reconnect the power cords to your computer and all attached devices.
Switching on your monitor
1.Switch on your computer.
2.Switch on the monitor power source by pushing the power switch A on side rear panel of the monitor. See Figure B on page 9.
3.Switch on your monitor by pushing and releasing the power switch marked " 
" at the front of the bezel.
• To switch off your monitor, push and release the power switch again.
4.To update or install device drivers, follow the instructions in the Device driver installation section on page 11.
5.If you are using the analog connector, run Image setup by following the instructions in the Automatic Image setup section on page 14.
10
