DiskOnChip (DOC) 2000 Installation
When the DOC is installed correctly, a DOC will work like an HDD or an FDD. To install the DOC on the mainboard, follow the instructions below:
1.Plug the DOC into the socket. Make sure pin 1 of the DOC is aligned with pin 1 of the socket.
2.Push the DOC into the socket until it is firmly seated in the socket.
Caution: the DOC may be permanently damage if it is installed incorrectly.
3. Set the jumper for the memory address of the DOC.
Note:
The memory shadow function sometimes will create conflicts with the memory window. You should disable the memory shadow from the BIOS SETUP if the DOC cannot be accessed.
Configure DOC as a boot device
To configure a DOC as a boot drive, you should copy the operating system files onto the DOC. The following procedure is an example of the initialization process.
1.Install a DOC into your system.
2.Insert a bootable floppy disk in drive A: and boot the system.
3.At the DOS prompt, type SYS C: to transfer the DOS system files to the DOC (assuming the DiskOnChip is installed as drive C:). Reboot the system.
4.Go to the BIOS Setup Utility by hitting the <DEL> key. Set the type of Primary Master or C: Drive as Not Installed.
5.Remove the floppy disk from the drive A: and leave the BIOS Setup Utility. The system should boot from the DOC.
42
