9
DEUTSCH ENGLISHFRANÇAISESPAÑOLITALIANOJAPANESECOMPL & WARR
Auto Setup(Analog Only)Auto Setup
Before carrying out this
section, it is very
important that The
Setup Diskette for Windows
95 or Windows 98 has been
run. (see page6)
The Setup Utility
included on the setup
diskette is for displaying do
patterns. They do not replace
or modify the display dirver.
The Auto Setup
instructions require the
monitor to be warmed up for
15 minutes. This is not
required for normal operation.
When you first use your monitor you must perform Auto Setup. This
procedure sets up your monitor to process the video signals from your
computer without image discoloration or smearing. After you perform Auto
Setup, the settings are stored and used each time you turn on the monitor.
In order to optimise the displayed image a set-up utility is provided on the IBM
Monitor Installation Diskette. Operation of the utility is dependent on the
operating system on your PC. For correct operation locate the operating
system on your PC from the table below and follow the appropriate
instructions. You may choose to run AUTO SETUP for each operating system
that you use. This means that if you sometimes use your monitor while
running any version of Windows and sometimes also use it from within DOS
(not a DOS window), you must run AUTO SETUP for both Windows and DOS.
You may run versions of AUTO SETUP in any order.
If your PC does not run
with the setup diskettes
shipped with the monitor, refer
to Manual Setup on page 12
Before you begin AUTO SETUP for your PC:
1. Make a backup copy of the setup diskettes supplied with the monitor.
2. Make sure the PC’s video mode is set in the range of the supported
screen resolution shown in the table on page18.
The AUTO SETUP process
only applies to the current
screen mode. When a new
mode is selected, repeat this
section to reset the monitor
You should perform AUTO SETUP for each screen mode you use.
Operating System Corresponding Auto Setup procedure
DOS Auto Setup for DOS on page 9
Windows 3.1
Auto Setup for Windows 3.1, Windows 95,
Windows 98, Windows 2000 or Windows
NT on page 10
Windows 95
Windows 98
Window 2000
Window NT
T84H_setup0926_final.fm Page 9 Thursday, October 5, 2000 8:45 AM