IBM WRT-410 Chapter 2 Hardware Installation, 2.1Hardware Connection, 2.2 LED Indicators, LED, PWR, WAN, LAN, WLAN, STATE, STATUS, MEANING

Chapter 2 Hardware Installation

Before you proceed with the installation, it is necessary that you have enough information about the WRT-410.

2.1Hardware Connection

1.Locate an optimum location for the WRT-410.The best place for your WRT-410 is usually at the center of your wireless network, with line of sight to all of your mobile stations.

2.Adjust the antennas of WRT-410.Try to adjust them to a position that can best cover your wireless network. The antenna’s position will enhance the receiving sensitivity.

3.Connect RJ-45 cable to WRT-410 LAN port. Connect one of the LAN ports on WRT-410 to your LAN switch/hub with a RJ-45 cable.

4.Connect RJ-45 cable to WRT-410 WAN port. Connect ADSL/Cable Modem to the WAN port on WRT-410. Use the cable supplied with your modem. If no cable was supplied with your modem, please use a RJ-45 Ethernet cable

5.Plug in power adapter and connect to power source. After power on, WRT-410 will start to operate.

Note: ONLY use the power adapter supplied with the WRT-410. Otherwise, the product may be damaged.

Note: If you want to reset WRT-410 to default settings, press and hold the Reset button over 5 seconds. And then wait for 10 seconds for WRT-410 restart.

2.2 LED Indicators

						LAN		802.11g
WRT-410	PWR	STATUS	WAN WLAN	1	2	3	4	Wireless Router
LED	STATE	MEANING
PWR	Green	Device power on
	Off	Device power off
STATUS	Green	Indicates a connection error
WAN	Green	WAN link status is on
	Blinking Green	WAN activity
WLAN	Green	WLAN link status is on
	Blinking Green	WLAN activity
LAN 1	Green	Link is established
	Blinking Green Packets are transmitting or receiving
2	Green	Link is established
	Blinking Green Packets are transmitting or receiving
3	Green	Link is established
	Blinking Green	Packets are transmitting or receiving
4	Green	Link is established
	Blinking Green	Packets are transmitting or receiving
			- 4 -