Icom AT-141 ■PL-259connector, ■Mounting, Mounting on a Mast/Metal pole, WARNING:, Mounting on a ﬂat surface

10 mm

q Slide the coupling ring over the coaxial cable. Strip the cable jacket and pull back to reveal 10 mm of braid.

• Soft solder the exposed braid and then pull out the jacket.

Coupling30 mm

10 mm (soft solder)

w Strip the cable as shown below. Soft solder the cen- ter conductor the entire length of the exposed braid.

1–2 mm

soft solder

INSTALLATIONS 2

■PL-259 connector

e Slide the connector body over the cable and solder as shown below.

Solder Solder

r Screw the coupling ring onto the connector body.

10mm 3⁄8 inches

■Mounting

Attach the AT-141 either horizontally or vertically with one of the water drains facing downwards. After mounting, remove the screw in the water drain.

Mounting on a Mast/Metal pole

Mast/ Using U-bolts

Metal pole

U-bolt

U-bolt plate

Flat washer(L)

Spring washer

Flat washer(S)

Nut

WARNING: Mount the AT-141 securely with the supplied nuts and bolts. Otherwise, vibrations and shocks due to waves, etc. could loosen the antenna tuner making if fall, causing personal injury.

Mounting on a ﬂat surface

Using nuts and bolts	Using self-tapping
	screws

Nut

Flat washer(S) Spring washer

Flat washer(L)

	Flat	Weatherproof cap
	washer(L)
		Drill a hole here
	Hex head
		Diameter:7–8 mm; 9⁄32–5⁄16inches
	bolt