Icom IC-F110, IC-F210 instruction manual Table of Contents

DO NOT use or place the transceiver in areas with tem- peratures below –30°C (–22°F) or above +60°C (+140°F), or in areas subject to direct sunlight, such as the dashboard.

AVOID operating the transceiver without running the vehi- cle’s engine. The vehicle’s battery will quickly run out if the transceiver transmits while the vehicle’s engine OFF.

AVOID placing the transceiver in excessively dusty envi- ronments.

AVOID placing the transceiver against walls. This will obstruct heat dissipation.

AVOID the use of chemical agents such as benzine or alcohol when cleaning, as they damage the transceiver sur- faces.

BE CAREFUL! The transceiver will become hot when operating continuously for long periods.

For U.S.A. only

CAUTION: Changes or modifications to this transceiver, not ex- pressly approved by Icom Inc., could void your authority to operate this transceiver under FCC regulations.

TABLE OF CONTENTS
IMPORTANT	i
EXPLICIT DEFINITIONS	i
PRECAUTION	i
TABLE OF CONTENTS	ii
1 PANEL DESCRIPTION	1–6
■ Front panel	1
■ Function display	2
■ Programmable function keys	3
2 OPERATION	7–10
■ Turning power ON	7
■ Channel selection	7
■ Receiving and transmitting	8
DTransmitting notes	8
DTX code channel selection	9
DTX code number selection	9
DDTMF transmission	9
DScrambler function	9
DUser set mode	10
3 OPTIONAL SmarTrunk IITM OPERATION	11–12
■ SmarTrunk IITM and conventional modes	11
■ SmarTrunk IITM operation	11
4 CONNECTION AND MAINTENANCE	13–17
■ Rear panel and connection	13
■ Supplied Accessories	14
■ Mounting the transceiver	15
■ Optional UT-105, UT-108 or UT-111 installation	15
■ Optional UT-109 or UT-110 installation	16
■ Optional OPC-617 installation	16
■ Antenna	17
■ Fuse replacement	17
■ Cleaning	17
5 OPTIONS	18

ii