Icom ic pw1 1 Rear panel

qOUTPUT ANTENNA CONNECTORS

[ANT1] – [ANT4] (p. 6)

Accept a 50 Ωantenna with a PL-259 connector.

wACCESSORY SOCKET-1 [ACC-1]

ACCESSORY SOCKET-2 [ACC-2]

Enable connection to Icom exciters (transceivers).

- See the page at right for socket information.

- The [ACC-2] socket is connected in parallel with [ACC-1]

by default and can be used for connecting external

equipment such as the EX-627 AUTOMATIC ANTENNA SE-

LECTOR, etc.These sockets can be separated by the

[EXCITER] switch. (!0)

eREMOTE CONTROLLER CABLE HOLE

[CONTROLLER](p. 10)

Used for separation of the remote controller and lin-

ear ampliﬁer.

rALC OUTPUT JACKS [ALC1]/[ALC2](p. 11)

Connect to the ALC input jack of a non-Icom exciter

(transceiver).

- Control voltage: –10 to 0 V DC

tSEND CONTROL JACKS [SEND1]/[SEND2]

(pgs. 8, 9)

Input terminals for transmit control. Go to ground

while transmitting.

- Max. control level: 5.0 V DC/0.1 A

- Ground level: –0.5 to 0.8 V DC

yCI-V REMOTE CONTROL JACKS [REMOTE]

(pgs. 7–9)

Used for band control with an Icom CI-V exciter

(transceiver).

uALC LEVEL ADJUSTMENT POTS

[ALC adj1]/[ALC adj2](p. 11)

Adjust the ALC levels.

RCAUTION! DO NOToperate the IC-PW1 be-

fore adjusting the [ALC adj1] and [ALC adj2] pots

properly.This may damage the ﬁnal FETs.

iCIRCUIT BEAKERS(p. 14)

Cut off the AC input when over current occurs.

- Circuit breaker capacity: 20 A (U.S.A. version)

15 A (Europe version)

oGROUND TERMINAL(p. 6)

Connect this terminal to a ground to prevent electri-

cal shocks, TVI, BCI and other problems.

1PANEL DESCRIPTION

■Rear panel

ANT4

ACC-2 ALC2

REMOTE ALC adj2

SEND2 ALC1SEND1

EXCITER

CONTROLLER

ACC-1

ANT3 ANT2 ANT1 INPUT1

INPUT2

1&2

REMOTE ALC adj1